Species Correction Table
For pin-type moisture meters that do not have wood species corrections built in, manual correction is required. Delmhorst uses Douglas Fir, the USDA standard, as the basis for all wood calibrations. Because the electrical characteristics of different species vary, all species read differently at the same moisture content.
*Meter readings taken with 26-E 2-pin electrode with insulated pins. Do not apply 2-pin correction.
▲ SPF correction is based on USDA/Forintek data and can be used for the following species: Lodgepole Pine, Alpine Fir, Eastern White Spruce, Black Spruce, Jack Pine
For meters that do not have temperature corrections built in, manual correction is required. As wood temperature increases, its electrical resistance decreases and indicated moisture content rises. Lower wood temperatures result in lower indicated moisture content. If the wood temperature, which is typically the ambient temperature, is between 50°F/10°C and 90°F/32°C, there is no need to apply a correction.
Moisture Content values shown in Bold are only qualitative since they are above fiber saturation point (30%MC).
For meters that do not have pin corrections built in, manual correction is required. The default calibration on our pin meters was made with non-insulated pins that penetrate 5/16 inch. Since insulated pins read slightly lower than noninsulated ones, refer to this correction table when using an electrode with insulated pins, such as the 26-ES.
METER READINGS WITH INSULATED PINS (26-ES ELECTRODE)
CORRECTED READINGS (TRUE INDICATED MOISTURE CONTENT)
Spacific Gravity Pinless Meter Corrections
Measurements obtained with pinless (capacitance type) moisture meters such as Delmhort TechScan pr Wagner Orion are greatly influenced by the specific gravity of the wood. Wood with higher specific gravity produces higher moisture readings than materials with lower specific gravity at the same moisture content.
For example Delmhorst TechScan is calibrated for wood at a specific gravity (SG) of 0.46, a correction is required when measuring wood species with SG values other than 0.46. Refer to the owner's manual for more information on SG corrections.